Make certain you have read the Kodak Ektagraphic III ATS Slide Projector manual thoroughly before attempting the Kodak Ektagraphic III ATS Slide Projector bulb replacement on your Kodak Ektagraphic III ATS Slide Projector. Without touching the surface of the Kodak Ektagraphic III ATS Slide Projector lens, remove the lens tube and set it aside. Write down the number from inside the tube's inner lip for the purpose of make, model or serial number for any future need to buy Kodak Ektagraphic III ATS Slide Projector replacement parts. Your bulb should be sitting just beyond the opening of the Kodak Ektagraphic III ATS Slide Projector body. Reach in with two fingers and disconnect the Kodak Ektagraphic III ATS Slide Projector bulb. Reverse these steps to re-assemble your Kodak Ektagraphic III ATS Slide Projector. This concludes the Kodak Ektagraphic III ATS Slide Projector review - be sure to read the entire Kodak Ektagraphic III ATS Slide Projector manual.